Sunday, 18 October 2009

Body Panels


Started fitting the body panels.
The right angle chucks and cobalt stubby drills made the job much easier. I also bought a vice mounted sheet metal bender.
The panels fitted in order are:
1.Footwell front - both sides
2. Footwell Inner - both sides
3. Tunnel panels - passenger
4. Rear bulkhead panel

Tuesday, 29 September 2009

Gearbox modification - BGH Geartech Ltd

I have sent my gearbox to BGH Geartech Ltd for modification to match the gear raitios to the engine and differential ratio to give me a linear performance across the range.

Based on my 170bhp Zetec and Diff Ratio of 3.92 I have opted for the following.

Fast Road - E3 – 2.0 Sporting Close – Heavy Duty
Gear - Ratio - MPH
1st - 2.92 - 41 mph
2nd - 1.86 - 65 mph
3rd - 1.295 - 93 mph
4th - 1.00 - 121 mph
5th - 0.85 - 142 mph

Sunday, 27 September 2009

Gearbox Mount

The gear box mount fitted in place.
The location dead central over the hole allows around 20mm play (forward/backward) which GBS confirmed is acceptable for a Type 9 gear box installation. The width of the standard Ford engine mount needs to reduced slightly to fit between the chassis rails. I fitted a washer between the mount and the chassis to raise the mount clear off the countoured underside (saves having to alter the chassis or the mount).

Friday, 28 August 2009

Hand Brake




At last we have some progress - after much deliberation I settled on using the standard Ford Hand Brake as it best fitted the chassis mountings and gave the best positioning.



The saddle had to be mounted below the hand brake linkage to avoid it catching on the chassis when the hand brake is pulled.
This was done by tapping the linkage to lower the saddle position.
As the standard Ford Sierra cable inner is too long for this application it was cut in the middle and jointed using "Gripples"


Routing the cable was fairly straight foward once I accepted that the holes in the chassis weren't a perfect fit and that I would have to cut the standard cable fittings off and custom fit new ones .

Monday, 27 July 2009

Rear of the Year

Thanks to a few rainy days I managed to get the the drive shafts, wish bone, hubs and discs bolted up. The final installation required several trial fits and adjustments to align everything. Once I was happy the bolts were loctite'd in place and a dob of blue paint applied so i could identify what was completed.









Wednesday, 15 July 2009

Installing 7" Sierra differential

Installation sequence (well mine)
1.Lift the differential into position
2.Fit the front bolts B & C to centralise the diff equally between the chassis plates. Check the hole alignment and make any adjustments to the size and location, once happy with the alignment remove bolts B&C.
3. The diff needs to be raised to allow access to install bolt A in to the slotted hole. The bolt is inserted from the drivers side. Once installed the diff can be lowered back to its final position to allow the remaining bolts to be installed.
Note: Make sure you install all washers and spacers before you lower the diff and install the other bolts.
4. Re-install bolts B & C.
5. Install bolt D.
6. Mark and drill the hole (10mm) for the rear diff mounting.
7. Install bolt E.

Tuesday, 14 July 2009

Differential

Having bought two Sierra 7" differentials - ratio 3.62:1 or 3.92:1 after much deliberation and discussion I decided that I would install the 3.92:1 unit as this will give me the best all round performance. I have also decided to upgrade the standard type 9 gearbox to BGH close ratio fast road specification (on the wish list). The diff was prepared (shot blasted and laquered) and ready for installation.